BREWART BEERDROID - Store

BREWART BY COOPERS
20
Store
The  zone brings your brew
to optimum temperature for
storage, this is pre-set to 4°C (39°F)
for  and  programs. In
a  program it will be the
temperature you set manually.
k The display screen will indicate
  .
k The temperature on the
display screen indicates the
current brew temperature.
k     will appear
on the display screen.
k Press

on the control panel to
transition the unit to  zone.
 Note
If your BeerDroid automatically
transitioned into  zone
and  was not detected
during the  zone,
see previous section 'End of
Fermentation not detected'.
Cancel & Leave a Program
To cancel and leave a program
at any time:
k Press

on the control panel.
k      will
appear on the display screen.
k To confirm cancellation, press

on
the control panel within 5 seconds
otherwise the program will resume.
 Note
To change temperature
display units (C & F) press
the thermometer button
on the control panel.
To illuminate the viewing
window, press the light
button on the control panel.
The light will automatically
switch o aer 15 seconds.