BREWART BEERDROID - Kegging Procedure using Keg Caddy; Attaching and Preparing Keg Components; Connecting Filling Tubes and Caps; Adding Ingredients and Final Setup

BEERDROID INSTRUCTIONS
23
Kegging using
theKegCaddy
1. Insert the Keg Caddy into the
two slots at the bottom of the
BeerDroid as shown; Ensure that
the Caddy is fully inserted into
the slots and securely engaged.
 Note
To keg without the use of the Keg
Caddy, please see how-to video at
BREWART.COM/101
2. Remove the yellow dust cap from
the keg liner and FIRMLY screw
on the Connector as shown.
3. The sleeve must remain
on the keg liner.
 Note
Take care not to allow any
unnecessary air into the Keg Liner.
The sleeve assists with this and
also plays an important role while
filling, do not remove it.
Be careful not to cross thread
the Connector, or damage the
Keg Liner.
4. Place the keg liner and connector
into the keg. Ensure the sleeve
remains on.
 WARNING
Do not twist counter clockwise,
this may loosen the seal
and result in leakage.