Broadcom NetXtreme BCM57 Series User Manual

Broadcom Gigabit Ethernet Teaming ServicesNetXtreme User Guide
Broadcom
®
April 2017 • 2CS57XX-CDUM514-R Page 135
Event Log Messages
• Windows System Event Log Messages
• Base Driver (Physical Adapter/Miniport)
• Intermediate Driver (Virtual Adapter/Team)
Windows System Event Log Messages
The known base driver and intermediate driver Windows System Event Log status messages for the Broadcom
NetXtreme Gigabit Ethernet adapters are listed in the following section. As a Broadcom adapter driver loads,
Windows places a status code in the system event viewer. There may be up to two classes of entries for these
event codes depending on whether both drivers are loaded (one set for the base or miniport driver and one set
for the intermediate or teaming driver).
Base Driver (Physical Adapter/Miniport)
Table 15 lists the event log messages supported by the base driver, explains the cause for the message, and
provides the recommended action.
Table 15: Base Driver Event Log Messages
Message
Number
Message Cause Corrective Action
1 Failed to allocate memory for the
device block. Check system
memory resource usage.
The driver cannot allocate
memory from the operating
system.
Close running applications
to free memory.
2 Failed to allocate map registers The driver cannot allocate
map registers from the
operating system.
Unload other drivers that
may allocate map registers.
3 Failed to access configuration
information. Reinstall the network
driver.
The driver cannot access
PCI configuration space
registers on the adapter.
For add-in adapters: reseat
the adapter in the slot, move
the adapter to another PCI
slot, or replace the adapter.
4 The network link is down. Check to
make sure the network cable is
properly connected.
The adapter has lost its
connection with its link
partner.
Check that the network
cable is connected, verify
that the network cable is the
right type, and verify that the
link partner (for example,
switch or hub) is working
correctly.
5 The network link is up. The adapter has
established a link.
Informational message only.
No action is required.
6 Network controller configured for
10Mb half-duplex link.
The adapter has been
manually configured for the
selected line speed and
duplex settings.
Informational message only.
No action is required.

Broadcom NetXtreme BCM57 Series Specifications

General

Brand	Broadcom
Model	NetXtreme BCM57 Series
Category	Controller
Language	English