iSCSI Protocol and Broadcom Boot Agent SoftwareNetXtreme User Guide
Broadcom
®
April 2017 • 2CS57XX-CDUM514-R Page 153
Virtual LANs
Virtual LAN (VLAN) tagging is not supported for iSCSI boot with the Microsoft iSCSI Software Initiator.
Troubleshooting iSCSI Boot
The following troubleshooting tips are useful for iSCSI boot.
Problem: The Broadcom iSCSI Crash Dump utility will not work properly to capture a memory dump when the
link speed for iSCSI boot is configured for 10 Mbps or 100 Mbps.
Solution: The iSCSI Crash Dump utility is supported when the link speed for iSCSI boot is configured for 1
Gbps. 10 Mbps or 100 Mbps is not supported.
Problem: An iSCSI target is not recognized as an installation target when you try to install Windows Server 2008
by using an IPv6 connection.
Solution: This is a known third-party issue. See Microsoft Knowledge Base KB 971443, http://
support.microsoft.com/kb/971443.
Problem: The iSCSI configuration utility will not run.
Solution: Ensure that the iSCSI Boot firmware is installed in the NVRAM.
Problem: After configuring the iSCSI boot LUN to 255, a system blue screen appears when performing iSCSI
boot.
Solution: Although Broadcom’s iSCSI solution supports a LUN range from 0 to 255, the Microsoft iSCSI
software initiator does not support a LUN of 255. Configure a LUN value from 0 to 254.
Problem: Unable to update inbox driver if a non-inbox hardware ID present.
Solution: Create a custom slipstream DVD image with supported drivers present on the install media.
To Next Page
Loading...
Need help?
General
