Broadcom NetXtreme BCM57 Series User Manual

TroubleshootingNetXtreme User Guide
Broadcom
®
April 2017 • 2CS57XX-CDUM514-R Page 162
4. Power down the machine, remove AC power from the machine, and then reboot the system.
5. Remove and re-install the diagnostic software.
6. Contact your hardware vendor.
BACS Network Test Failures
Typically, the BACS Testing the Network failures are the result of a configuration problem on the network or with
the IP addresses. Below are common steps when troubleshooting the network.
1. Verify that the cable is attached and you have proper link.
2. Verify that the drivers are loaded and enabled.
3. Replace the cable that is attached to the NIC/LOM.
4. Verify that the IP address is assigned correctly using the command "ipconfig" or by checking the OS IP
assigning tool.
5. Verify that the IP address is correct for the network to which the adapter(s) is connected.

Broadcom NetXtreme BCM57 Series Specifications

General

Brand	Broadcom
Model	NetXtreme BCM57 Series
Category	Controller
Language	English