Linux Driver and Management Application InstallationNetXtreme User Guide
Broadcom
®
April 2017 • 2CS57XX-CDUM514-R Page 42
Enable Authentication
The following OpenPegasus properties have to be set as described in this section. Otherwise, the Broadcom
CIM Provider will not work properly. Ensure the following are set before launching BACS and connecting to the
provider.
Start CIM server if it is not already started. Then, set the following:
•
cimconfig -s enableAuthentication=true -p
• cimconfig -s enableNamespaceAuthorization=false -p
• cimconfig -s httpAuthType=Basic -p
• cimconfig -s passwordFilePath=cimserver.passwd -p
• cimconfig -s forceProviderProcesses=false -p
If you want root user to connect remotely:
•
cimconfig -s enableRemotePrivilegedUserAccess=true -p
User configuration with privilege: The Linux system users are used for OpenPegasus authentication. The
systems users have to be added to OpenPegasus using
cimuser to connect via BACS:
•
cimuser -a -u <username> -w <password>
Example: cimuser -a -u root -w linux1
Enable HTTP
1. If CIM server is not started, start it.
2. Use the following command to set up an HTTP port (optional):
cimconfig -s httpPort=5988 -p
This property is not available for Inbox OpenPegasus.
3. Use the following command to enable HTTP connection:
cimconfig -s enableHttpConnection=true -p
4. Use the cimserver -s and cimserver commands, respectively, to stop and restart CIM server for the new
configuration to take effect.
Enable HTTPS
1. If CIM server is not started, start it.
2. Set up HTTPS port with the following command (optional):
cimconfig -s httpsPort=5989 -p
This property is not available for inbox OpenPegasus.
3. Enable HTTPS connection with 'the following command:
cimconfig -s enableHttpsConnection=true -p
4. Use the cimserver -s and cimserver commands, respectively, to stop and restart CIM server for the new
configuration to take effect.
Step 4: Install Broadcom CMPI Provider
To Next Page
Loading...
Need help?
General
