Brooks Automation
108 278580 Revision A
7 Operation LF80C ZeniD RFID Reader
7.3 Operation of SECS Protocol Product Manual
Valid services per
status
The following table shows which of the various services can be performed
by the reader when the reader is in various individual statuses.
Service
Write ID
Write data
Set attributes
Reset
Read ID
Read data
Perform diag.
Request status
Request attributes
Change status
Reader status
INIT
IDLE/BUSY X X X X X X X X X
MANT X X X X X X X X
IMPORTANT
Note that the CIDRW may not be able to communicate when in
initializing status after power-up or reset service.
To Next Page
Loading...
