Brother GT-3 Series - Page 306

6. Replacing Parts
6.
Pass th
e Waste Ink Tube 1 (8) through the Cord Clamp 13-L (10).
(8)
(10)
7. Insert the Mai
ntenance Middle Tube 2 (12) into the Waste Ink Joint (11) until the Maintenance Middle
Tube 2 can reach to the end, less than 1 mm margin from the root.
(11
(12)
)
8. Fix the Waste
Ink Joint (11) on the Pump Holder (13) with the screw (14), with tightening torque 0.5 N·m,
and insert the Pump Tube (15) and the Joint (16) until to the end, less than 1 mm margin from the root.
(14)
(
11
)
(16)
(15)
(14)
(13)
GT-3 Series
297