Brother HL-2060 - Page 115

VII-2
Hex dump mode
* Printer reset is need to
exit this mode.
(No display reads) Reads the date of program /
font ROM. Press CONT to
switch program and font.
(No display reads) Choose LCD local prompt
message.
(No display reads) NV-RAM settings returns to
the factory default settings.
These settings are reset in
addition to the factory reset.
• Interface
• Page Protect
• HRC
• Panel Lock
• Toner Density
(No display reads) Check DRAM strictly.
Write the data recieved
through the parallel I/F onto
flash memory modules on
the main ROM socket.
Write the data which is
stored on a PCMCIA card
onto flash memory modules
on the main ROM socket.
Write the data recieved
through the parallel I/F onto
flash memory modules on
the option ROM socket.
Write the data which is
stored on a PCMCIA card
onto flash memory modules
on the option ROM socket.
Write the data recieved
through the parallel I/F onto
patch flash memory
modules.
Write the data which is
stored on a PCMCIA card
onto patch flash memory
modules.
Write the data on the option
ROM onto flash memory
modules on the main ROM
socket.
▼
HEX DUMP MODE
PRL ---->MAIN ROM W
CARD --->MAIN ROM W
PRL ---->OPTN ROM W
CARD --->OPTN ROM W
PRL ---->PTCH ROM W
CARD --->PTCH ROM W
OPTN --->MAIN ROM W
CONTINUE
FONT
FORM FEED
SET
CONTINUE
FORM FEED
FONTMODE
SEL