IV-28
(3) Open the transfer base hook and take off the left bearing (white) from the hook
(
A
). Lift the left side (
B
), slide it to the left (
C
) and take off the roller shaft from
the right bearing (black) (
D
).
(4) Remove the transfer roller ASSY.
Caution: Do not touch the sponge rubber roller when replacing the transfer roller (the
roller with hand grease or clasped too strongly may result in poor printing
quality).
Figure 4.58
1.30 DC Gear Holder ASSY
(1) Remove the DC motor connector, then remove the Paper delivery holder spring.
(2) Loosen the 4 screws and remove the DC gear unit from the chassis.
(3) Remove the Paper delivery gear ASSY, the gears, the Gear 48 spring, and the
washer.
(4) Loosen the 3 screws and remove the DC motor ASSY from the gear holder.
Figure 4.60Figure 4.59
3 Hooks
Transfer roller ASSY
Transfer base ASSY
PS switch wire
Paper delivery
holder sprin
To Next Page
Loading...
