IV-16
1.15 P Feed /Size-SW PCB ASSY
(1) Release 2 solenoid harness connectors.
(2) Put the 3 chassis L tabs to their original position.
(3) Remove 2 screws securing the Size-SW PCB ASY and remove P Feed/Size-SW
PCB ASSY.
Figure 4.30
1.16 Size-Switch Spring
(1) Pull out the Size-switch spring.
Figure 4.31
1.17 Regist sensor actuator
(1) Remove the actuator by shifting it to the left from the chassis hole.
Regist sensor actuator
Regist sensor actuator
Size-SW PCB
Size-switch spring
Tabs
2 solenoid harness connector
2 screws
P feed/ size -SW PCB ASSY
Paper feed motor
harness connector
Figure 4.32
To Next Page
Loading...
