Brother HL-2060 - PE Sensor Actuator MP; Tray Sensor Holder

IV-17
1.18 PE Sensor Actuator MP
(1) Pull out the actuator by shifting it to the right from the chassis hole.
Figure 4.33
1.19 Tray Sensor Holder
(1) Disengage the DU (Duplex) detection actuator from the hook and slide it to the
outside.
(2) Loosen the screw and remove the holder by lifting it from the chassis.
PE sensor actuator tray, PE actuator link, DU detection actuator
1) Remove the PE actuator link from the PE sensor actuator tray.
2) Remove the PE actuator link from the Tray sensor holder.
3) Remove the PE sensor actuator tray from the Tray sensor holder.
4) Remove the DU detection actuator from the Tray sensor holder.
Figure 4.34
PE sensor actuator MP
PE sensor actuator MP
DU detection actuator
Hook
Screw
PE sensor actuator tray
Tray sensor holder
PE actuator link