IV-11
(6) Remove 8 screws and the Main PCB ASSY.
Figure 4.17
1.10 Laser Unit
(1) Unplug the LSR flat cable connector (6P), and LSR harness connector (14P).
(2) Remove the beam from the chassis by loosening the screws.
(3) Remove the Laser unit from the chassis by loosening the screws.
Caution: Do not disassemble the Laser unit, it can be only adjusted at the factory only.
8 screws
Main PCB ASSY
LSR flat cable 6P connector
LSR harness 14P
Laser unit
Screws
Screws
Beam
Polygon control PCB
Release the hook to loosen
the cable tie.
Figure 4.18
Figure 4.19
To Next Page
Loading...
