IV-10
(3) Remove the PCB holder by loosening 10 screws from the PCB holder, 2 screws
from the centronics connector and 2 screws RS-232C connector.
Figure 4.15
(4) Remove the SW panel harness 22P and the Paper feed flat cable 21P.
(5) Remove the DC fan motor harness 3P, the Fuser harness 4P, the Porigon harness
5P, the LSR flat cable 6P, the DC motor harness 5P, the HV harness 16P and the LV
harness 8P.
Figure 4.16
PCB holder
Screws
Main PCB
PCB holder
< View from the top >
Centronics connector lock wire
Paper feed flat cable 21P
Porigon harness 5P
HV harness 16P
DC motor harness 5P
LV harness 8P
SW panel harness
To Next Page
Loading...
