Brother HL-2060 - DC Fan Motor

IV-8
(2) Remove the Side cover R by releasing the 4 hooks.
Note: Before releasing the 4 hooks, remove the paper tray.
Figure 4.11
1.8 DC Fan Motor
(1) Remove the DC fan motor from the DC fan motor holder by loosening the 2
screws.
(2) Loosen the screws securing the Holder spacer and remove the entire DC fan
motor holder.
Figure 4.12
<Rear>
<Front>
Side cover R
Hook at 4 places
DC fan holder
2 screws
Screws (yellow)
DC fan motor
Holder spacer