IV-27
3) Remove the Pressure roller spring and Pressure roller bearing on both sides, and
the Pressure roller.
Note: Do not use the electric driver to loosen/secure the screw as the plastic bush is
easy to break.
Figure 4.56
< Reassembly >
Using the Release spacer L & R may help to assemble springs.
1.29 Transfer Unit
(1) Loosen a screw.
(2) Release the 3 right hooks, (see Figure 4.57) lift the right part of the unit (
A
) and
slide it to the right (
B
) (See Figure 4.56)to take off the left part from the main
chassis L. Remove the transfer unit from the body by lifting the former.
Figure 4.57
Pressure roller bearing
Pressure roller
Fixing unit chassis
Pressure roller spring
<Right>
Transfer unit
Screw
Main chassis L
A
B
To Next Page
Loading...
