Brother HL-2060 - Low-Voltage Power Supply PCB Assy

IV-30
(3) Loosen the 2 screws and remove the connector.
(4) Hold the head of 2 resin spacers and lift this side of PCB (
A
).
(5) Slide the PCB to the opposite side (
B
).
Figure 4.64
1.33 Low-Voltage Power Supply PCB ASSY
(1) Be sure to remove the heat insulation cover before removing the low-voltage
power supply block.
Figure 4.65
Heat insulation cover
Hook
Hook
Heat insulation cover
A
B
C
Resin spacers
High-voltage power supply
PCB ASSY
The PCB can be detached
without removin
g
this
Screws
Connector