Brother HL-2060 - Operation; Line Inspection Mode Procedure

VI-22
6. OPERATION
6.1 Line Inspection Mode Procedure
(1) Install flash memory cards 1 & 2 and an optional MIO board.
(2) While pressing the
switch, turn the power on.
The LCD will display: LINE TEST
(3) Press the SET switch to check if the LCD comes on.
(4) Press the CONTINUE switch to check the pushbutton switch.
All the LEDs will go out and the LCD will display the characters shown below:
Press all the switches by turns. The following LEDs will turn on by turns upon
pressing the pushubutton switch.
X X X X X X X X
È
1 2 3 4 5 6 7 8
Key number LED
Ready
Online
Data
Alarm
(5) Press the CONTINUE switch to check RAM size.
RAM SIZE = 8MB 8M (standard)
RAM SIZE = XXMB XX : Expanded SIMM + 8MB
RAM SIZE ERROR In case of error
(6) Press the CONTINUE switch to check the fan.
FAN HIGH SPEED Make sure that the fan rotates at the high speed.
Press the CONTINUE switch.
FAN LOW SPEED Make sure that the fan rotates at the low speed.
(7) Press the CONTINUE switch to check the 1st stage cassette.
TRAY 1 = A4 Appears when the cassette is set to A4 size.
TRAY 1 = LETTER Appears when the cassette is set to letter size.
TRAY 1 = NO Appears when no cassette is set.
TRAY 1 = NO Appears when no cassette is set and the
duplex sensor is on. The Alarm LED turns on.
CASSETTE ERROR!! Appears in case of error.
All the LCD elements will
come on simultaneously.
Switch key numbers
1
2
3
4 5
6
7
8
1
2
3
4