Brother HL-2060 - Printer Body; Configuration; Control Panel Unit

IV-3
PRINTER BODY
1.1 Configuration
Figure 4.1
1.2 Control Panel Unit
(1) Release the Stopper.
(2) Remove the Lead wire cover.
(3) Remove the 3 screws from the bottom of the Control panel unit, and remove the 3
screws from the Interlock actuator.
(4) Pull out the Harness connector.
Note: Carefully remove the Panel cover from the rib.
Figure 4.2
Toner cartridge lid
Upper cover ASSY
Control panel unit
Side cover L
Paper tray
Rear cover ASSY
Side cover R
Font cover ASSY
Screw
Screw
Control panel unit
(Bottom)
Lead wire cover
Interlock actuator