Brother HL-2060 - PS Switch Wire, Remote Switch; High-Voltage Power Supply PCB Assy

IV-29
1.31 PS Switch Wire, Remote Switch
(1) Pull out the PS switch wire from the remote switch and the switch attachment.
Lift slightly the wires when pulling them out. This is in order to release the chassis
caught at 2 places.
(2) Remove the remote switch from the chassis.
1.32 High-Voltage Power Supply PCB ASSY
(1) Release the 2 hooks at the bottom of the LV duct and slid it towards the left. Lift it
upwards to remove.
(2) Remove the LV fan.
Figure 4.63
Figure 4.62Figure 4.61
Switch attachment
PS switch wire
Remote
switch
Chassis
Remote switch
LV fan
LV duct