Brother HL-2060 - Page 118

VII-5
10mm grid pattern sheet
for offset print check
Adjust the top margin for feeding
from MP tray in the range from -
2.0 mm to +2.0 mm, by 0.5 mm
Adjust the top margin for feeding
from cassette tray in the range
from -2.0 mm to +2.0 mm, by 0.5
mm
Adjust the toner fixing temperature
for transparencies at 20 PPM
printing.
• Standard tenperature
• - 5 C from standard temperature
• + 5 C from standard temperature
• + 10 C from standard
temperature
Adjust the toner fixing temperature
for ragular paper at 20 PPM
printing.
• Standard tenperature
• - 5 C from standard temperature
• + 5 C from standard temperature
• + 10 C from standard
temperature
Adjust the toner fixing temperature
for thick paper at 20 PPM printing.
• Standard tenperature
• - 5 C from standard temperature
• + 5 C from standard temperature
• + 10 C from standard
temperature
Adjust the toner fixing temperature
for ragular paper at 10 PPM
printing.
• Standard tenperature
• - 5 C from standard temperature
• + 5 C from standard temperature
• + 10 C from standard
temperature
TEST PRN=GRID2
ENGINE ADJUST MP-CAS ADJUST
MP OFFSET
CAS OFFSET
exit
PRESSURE TEMPER.
TRANS 20PPM
REGUL 20PPM
THICK 20PPM
TRANS 10PPM