Brother HL-L2300d Series Service Manual

2-55
Confidential
 Error code BF00
The first side document scanning position sensor detected that the ADF was unable to
duplex-feed the document because the document length is 400 mm or longer.
 Error code C700
There is insufficient memory to expand PC print data.
Error code C800
The memory size allotted for Secure print was exceeded when saving Secure print data.
 Error code D100
An error occurred while initializing the modem.
Scan Unable
Document is too long for 2-sided scanning. Press Stop key.
<User Check>
• Set A4 or Letter size paper.
• Remove the jammed document.
Step Cause Remedy
1
First side document scanning
position actuator caught in some
sections of the machine
Reattach the first side document scanning
position actuator.
2
First side document scanning
position sensor failure
Replace the first side document scanning
position sensor PCB ASSY.
3
Main PCB failure Replace the main PCB ASSY.
Out of Memory
Press Stop Key.
Print Data Full
Print Data is full. Press Stop and delete the previously stored data.
<User Check>
• Print the print data stored in the memory.
• Divide the print data and print them separately.
Step Cause Remedy
1
Main PCB failure Replace the main PCB ASSY.
Print Unable D1
Turn the power off and then back on again.
Step Cause Remedy
1
Modem PCB failure Replace the modem PCB ASSY.
2
Main PCB failure Replace the main PCB ASSY.

Brother HL-L2300d Series Specifications

General

Functions	Print
Standard Paper Capacity (sheets)	250
Standard Interface(s)	USB 2.0
Print Resolution (maximum dpi)	2400 x 600 dpi
Recommended Monthly Print Volume	250 - 2, 000 pages
Operating System Compatibility	Windows, Mac, Linux