68
4
4
To use the machine as a network scanner, the machine must be configured with a TCP/IP address. You can
set or change the address settings from the control panel (See Control Panel Setup in the Network User’s
Guide) or by using the BRAdmin Professional software. If you installed the machine following the instructions
for a network user in the Quick Setup Guide then the machine should already be configured for your network.
Note
• For network scanning, a maximum of 25 clients can be connected to one machine on a network. For
example, if 30 clients try to connect at a time, 5 of those clients will not be shown on the LCD.
• If your PC is protected by a firewall, and is unable to scan you may need to configure the firewall settings
to allow communication through port number 137 and 54925. Visit the Brother Solutions Center
(http://solutions.brother.com
) for more information.
Before using Network Scanning 4
Network license 4
This product includes a PC license for up to 2 Users.
This license supports the installation of the MFL-Pro Software Suite including ScanSoft
®
PaperPort
®
SE on
up to 2 PCs on the network.
If you want to use more than 2 PCs with ScanSoft
®
PaperPort
®
SE installed, please buy the Brother NL-5
pack which is a multiple PC license agreement pack for up to 5 additional users. To buy the NL-5 pack,
contact your Brother dealer.
Network Scanning
(For models with built-in network support)
4
To Next Page
Loading...
Need help?
General
