74
5
5
Remote Setup 5
The Remote Setup program lets you configure many machine settings from a Windows
®
application. When
you start this application, the settings on your machine will be downloaded automatically to your PC and
displayed on your PC screen. If you change the settings, you can upload them directly to the machine.
Click the Start button, All Programs, Brother, MFC-XXXX, and Remote Setup.
Note
• If you are using the MFC-5460CN or MFC-5860CN with a network connection, you will be prompted to
enter a password. The default password is "access".
• For other models or if you are connected using USB, no password is required by default.
OK
Lets you start uploading data to the machine and exit the Remote Setup application. If an error message
is displayed, enter the correct data again and then click OK.
Cancel
Lets you exit the Remote Setup application without uploading data to the machine.
Apply
Lets you upload data to the machine without exiting the Remote Setup application.
Print
Lets you print the chosen items on the machine. You cannot print the data until it is uploaded to the
machine. Click Apply to upload the new data to the machine and then click Print.
Remote Setup (Not available for DCP
models and MFC-240C)
5
To Next Page
Loading...
Need help?
General
