Remote Setup & PhotoCapture Center™
152
For network cable users
(For models with built-in network support) 12
a Put a SmartMedia
®
, CompactFlash
® 1
, Memory Stick
® 2
, Memory Stick Pro ™, MultiMediaCard™,
SecureDigital™ or xD-Picture Card™
1
into your machine.
1
This product also supports CompactFlash
®
type1 and xD-Picture Card™ type M (Large Capacity).
2
A MagicGate Memory Stick
®
can be used, but any music data that is stored on the stick cannot be read.
b Launch any FTP software or any web browser in which FTP is supported. (e.g. Safari, Internet Explorer)
Your browser software accesses the media card using the FTP protocol and the network Host Name of
the machine. In the address bar, enter ftp://XXX.XXX.XXX.XXX (where XXX.XXX.XXX.XXX is the IP
address of your Brother machine).
Your browser software appears and a list of file names on your media card is shown.
c Click the name of the file you want to see.
When you take out a media card, do the following to prevent damage to the media card:
12
a Close the browser.
b Wait until the (PhotoCapture) key stops blinking before taking out the media card.
CAUTION
DO NOT unplug the power cord or remove a SmartMedia
®
, CompactFlash
®
, Memory Stick
®
, Memory Stick
Pro ™, MultiMediaCard™, SecureDigital™ or xD-Picture Card™ from the machine while it is reading the
card (when the (PhotoCapture) key is flashing). You could lose your data or damage the card.
If you take out the media card while the PhotoCapture key is flashing, you must restart your Macintosh
®
at once before putting the same media card back into the machine. If you do not restart your Macintosh
®
,
the data on your media card may be destroyed.
To Next Page
Loading...
Need help?
General
