Wireless configuration for Macintosh
®
54
5
11
To communicate with the un-configured wireless
machine, temporarily change the wireless settings
on your Macintosh
®
to match machine’s default
settings shown on this screen. Click Next.
12
If more than one wireless machine is available on
the network, the following list appears. If the list is
blank, check that the access point and the machine
are powered on, and then click Refresh. Choose the
machine you wish to configure, and click Next.
Note
The Default Node name of the NC-xxxx (where “xxxx” is
your model name) is “BRW_xxxxxx” (where “xxxxxx” is the last six digits of Ethernet address).
Item Record the current wireless computer settings
Communication mode:
(Infrastructure/Ad-hoc)
Channel: (1-14)
Network name
(SSID/ESSID)
Authentication method
(Open system/Shared key)
Encryption:
(None/WEP/WPA/WPA2-PSK/
LEAP)
Encryption key:
To Next Page
Loading...
