Wireless configuration for Macintosh
®
55
5
13
The wizard will search for wireless networks
available from your machine. If more than one
wireless network is available, the following list
appears. Choose the access point you wish to
associate the machine with, and then click Next.
Note
• If the list is blank, check that the access point has
power and is broadcasting the SSID, and then see
if the machine and the access point are within
range for wireless communication. Then, click
Refresh.
• If your access point is set to not broadcast the
SSID you can manually add it by clicking the Add
button. Follow the on-screen instructions for
entering the Name (SSID) and the Channel
number.
• "SETUP" is the default SSID of the machine. Do
not choose this SSID.
14
If your network is not configured for Authentication
and Encryption, the following screen will appear. To
continue installation, click OK and go to step 16.
15
If your network is configured for Authentication and
Encryption, the following screen will appear. When
configuring your Brother wireless machine, you must
ensure that it is configured to match the
Authentication and Encryption settings of your
existing wireless network. Choose the
Authentication Method and Encryption Mode
from the pull-downs in each setting box. Then enter
the Network key and click Next.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
