Wireless configuration for Macintosh
®
56
5
Note
• If you want to set more than one WEP key, click Advanced.
• If you do not know the Authentication or Encryption settings for network, contact your network
administrator.
16
Click Next. The settings will be sent to your
machine. The settings will remain unchanged if you
click Cancel.
If you chose to use a network cable in step 7, go to
step 17.
If you chose not to use a network cable in step 7, go
to step 18.
Note
• If you want to manually enter the IP address settings of your machine, click Change IP Address and
enter the necessary IP address settings for your network.
17
Disconnect the network cable between your access
point (hub or router) and the machine, and click
Next. Go to step 19.
Note
Wireless communication will not start until you have disconnected the network cable.
To Next Page
Loading...
