Brother MFC-9450CDN - Setting the Print Density; Additional Receiving Operations; Printing a Reduced Incoming Fax

Chapter 6
42
If this feature is set to On, but your machine
does not connect a fax call when you lift the
handset of an extension or external
telephone, press l51 on the external or
extension telephone. (See Operation from
extension telephones on page 47.)
Note
• You need to turn the Remote Codes setting
to on to use the Fax Receive Code
l 51.
(See
Using remote codes on page 49 .)
• If you use a modem, or send faxes from a
computer, on the same line and your
machine intercepts them, set fax detect to
Off.
a Make sure you are in Fax mode .
b Press Menu, 2, 1, 3.
Setup Receive
3.Fax Detect
c Press a or b to choose On or Off.
Press OK.
d Press Stop/Exit.
Setting the print density 6
You can adjust the print density to make your
printed pages darker or lighter.
a Make sure you are in Fax mode .
b Press Menu, 2, 1, 7.
Setup Receive
7.Print Density
c Press a to make the print darker.
Or, press b to make the print lighter.
Press OK.
d Press Stop/Exit.
Additional receiving
operations 6
Printing a reduced incoming
fax 6
If you choose On, the machine automatically
reduces each page of an incoming fax to fit on
one page of A4, Letter, Legal or Folio size
paper.
The machine calculates the reduction ratio by
using the page size of the fax and your Paper
Size setting (Menu, 1, 3).
a Make sure you are in Fax mode .
b Press Menu, 2, 1, 5.
Setup Receive
5.Auto Reduction
c Press a or b to choose On (or Off).
Press OK.
d Press Stop/Exit.