Brother MFC-9450CDN - Tray Selection

Chapter 12
76
If you are copying from the ADF: 12
Insert your document face up in the direction
shown below:
 2 in 1 (P)
 2 in 1 (L)
 4 in 1 (P)
 4 in 1 (L)
If you are copying from the scanner
glass: 12
Insert your document face down in the
direction shown below:
 2 in 1 (P)
 2 in 1 (L)
 4 in 1 (P)
 4 in 1 (L)
Tray selection 12
You can change the tray use only for the next
copy.
a Make sure you are in Copy mode .
b Load your document.
c Use the dial pad to enter the number of
copies (up to 99).
d Press Options.
Press a or b to choose Tray Select.
Press OK.
e Press a or b to choose the MP>T1,
T1>MP, #1(XXX)
1
and MP(XXX)
1
.
Press OK.
f Press Mono Start or Colour Start.
1
XXX is the paper size you set in Menu, 1, 3.
Note
• T2 or #2 appears only if the optional paper
tray is installed.
• To change the default setting for Tray
Select, see Tray use in copy mode
on page 21.
Choose
Tray Select
MP>T1 or MP>T1>T2
T1>MP or T1>T2>MP
#1(XXX)
1
#2(XXX)
1
MP(XXX)
1