Configuring your machine for a network with an Ethernet cable connection
15
2
c Double-click the unconfigured device.
Note
• If the print server is set to its factory default settings without using a DHCP/BOOTP/RARP server, the
device will appear as Unconfigured in the BRAdmin Light utility screen.
• You can find the node name and Ethernet address by printing the Network Configuration List. See Printing
the Network Configuration List on page 105 for information on how to print the Network Configuration List
on your print server.
d Choose Static from Boot Method. Enter the IP address, Subnet Mask and Gateway (if needed) of
your print server.
e Click OK.
f With the correctly programmed IP address, you will see the Brother print server in the device list.
Windows
®
Macintosh
®
Windows
®
Macintosh
®
To Next Page
Loading...
