Wireless Configuration for Macintosh
®
63
5
m The following list appears. If the list is blank, check if the access point and the machine are powered on,
and then click Refresh. Choose the machine you wish to configure, and click Next.
Note
The default node name of the NC-xxxx (where “xxxx” is your model name) is “BRNxxxxxx” or “BRWxxxxxx”
(where “xxxxxx” is the last six digits of Ethernet address).
n The wizard will search for wireless networks available from your machine. Choose the access point you
wish to associate the machine with, and then click Next.
To Next Page
Loading...
