To Next Page

To Previous Page

5-8

Confidential

1.3.5 Set worker switches (WSW) and print worker switch setting data

(Function code 10, 11)

[1] Set worker switches (Function code 10)

The worker switches shown in the table below can be used to set the function to satisfy various

requirements. These switch settings can be changed using the keys on the control panel.

The worker switches are factory set to conform to the laws and regulations of the country the

machine is shipped to. Do not change these settings unless necessary.

WSW No. Function WSW No. Function

WSW01 Dial pulse setting WSW38 V.34 transmission settings

WSW02 Tone signal setting WSW39 V.34 transmission speed

WSW03 PABX mode setting WSW40 V.34 modem settings

WSW04 Transfer facility setting WSW41 ON-duration of the scanning light

source

WSW05 1st dial tone and busy tone

detection WSW42 Internet mail settings

WSW06 [Redial/Pause] and 2nd dial tone

detection

WSW43 Function setting 16

WSW44 Speeding up scanning-1

WSW07 Dial tone setting 1 WSW45 Speeding up scanning-2

WSW08 Dial tone setting 2 WSW46 PC power monitoring and

parallel port settings

WSW09 Protocol definition 1

WSW10 Protocol definition 2 WSW47 Switching between high- and full-

speed USB

WSW11 Busy tone setting

WSW12 Signal detection condition setting WSW48 USB setup latency

WSW13 Modem setting WSW49 End-of-copying beep

WSW14 AUTO ANS facility setting WSW50 SDAA setting

WSW15 Redial facility setting WSW51 Function setting 17

WSW16 Function setting 1 WSW52 Function setting 18

WSW17 Function setting 2 WSW53 Function setting 19

WSW18 Function setting 3 WSW54 Function setting 20

WSW19 Transmission speed setting WSW55 Interval for regular developing

bias value correction

WSW20 Overseas communication mode

setting WSW56 Function setting 21

WSW21 TAD setting 1 WSW57 Function setting 22

WSW22 ECM and call waiting caller ID WSW58 Function setting 23

WSW23 Communication setting WSW59 Function setting 24

WSW24 TAD setting 2 WSW60 Function setting 25

WSW25 TAD setting 3 WSW61 Scanning light intensity to judge

to be stable 1

WSW26 Function setting 4

WSW27 Function setting 5 WSW62 Scanning light intensity to judge

to be stable 2

WSW28 Function setting 6

WSW29 Function setting 7 WSW63 Function setting 26

WSW30 Function setting 8 WSW64 Language / default paper size

setting

WSW31 Function setting 9

WSW32 Function setting 10 WSW65 Paper support setting

WSW33 Function setting 11 WSW66