Printing photos from a memory card or USB Flash drive
85
10
PhotoCapture Center™
print settings
10
You can temporarily change the print settings
for the next print.
The machine returns to its default settings
after 1 minute.
You can save the print settings you use
most often by setting them as the default.
(See Advanced User’s Guide: Setting
your changes as a new default.)
How to scan to a
memory card or USB
Flash drive
10
You can scan monochrome and colour
documents to a memory card or USB Flash
drive. Monochrome documents will be stored
in PDF (*.PDF) or TIFF (*.TIF) file formats.
Colour documents may be stored in PDF
(*.PDF) or JPEG (*.JPG) file formats. The
factory setting is Colour, 200 dpi and the
default format is PDF. The machine creates
file names based on the current date.
(See Quick Setup Guide.) For example, the
fifth image scanned on July 1, 2013 would be
named 01071305.PDF. You can change the
colour and resolution.
a Load your document.
If you want to scan a 2-sided document,
load your document in the ADF.
You can scan a 2-sided document up to
A3 or Ledger size from the ADF except
when using ADF High Speed Mode.
b Open the media slot cover.
c Put the memory card or USB Flash drive
in the proper slot.
d Press Scan to Media.
DO NOT take out the memory card or
USB Flash drive while the machine is
reading or writing to it to avoid damaging
the card, USB Flash drive, or the data
stored on them.
e Press Options.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
