IV - 68
1.28 Clutch Levers, Cassette Guide L, and Solenoid
(1) Turn the main chassis upside down.
(2) Remove the two screws and take off the front underbar (which is shown on page IV-61).
(3) Place the main chassis rightside up.
(4) Remove the clutch lever F/R by pulling its pawl outwards.
(5) Remove the clutch lever spring and clutch lever P/R.
(6) Remove the plunger and solenoid release spring.
(7) Remove two screws "a" and take off the cassette guide L.
(8) Remove screw "b" and take off the solenoid.
Reassembling Notes
• Route the solenoid harness through three latches and pass it through the square hole provided
in the left-hand plate of the main chassis.
"a": Taptite, cup S M3x6
"b": Screw, bind M3x4
To Next Page
Loading...
