V - 11
Firmware Switches (WSW01 through WSW50) Continued
WSW No. Function
WSW38 Function setting 16
WSW39 Function setting 17
WSW40 Function setting 18
WSW41 Function setting 19
WSW42 Function setting 20
WSW43 Function setting 21
WSW44 Speeding up scanning-1
WSW45 Speeding up scanning-2
WSW46 Monitor of power ON/OFF state and parallel port kept at high
WSW47 Delay of FAX line disconnection
WSW48 Not used.
WSW49 Not used.
WSW50 Not used.
n
nn
n Operating Procedure
(1) Press the 1 and 0 keys in this order in the initial stage of the maintenance mode.
The machine displays the "WSW00" on the LCD and becomes ready to accept a firmware
switch number.
(2) Enter the desired number from the firmware switch numbers (01 through 50).
The following appears on the LCD:
Selector 1 Selector 8
↓↓
WSWXX = 0 0 0 0 0 0 0 0
(3) For machines w/ fax: Use the and keys to move the cursor to the selector position to
be modified.
For machines w/o fax: Use the Reset key to move the cursor to the selector position to be
modified.
(4) Enter the desired number using the 0 and 1 keys.
(5) For machines w/ fax: Press the Set key.
For machines w/o fax: Press the Menu key.
This operation saves the newly entered selector values onto the EEPROM and readies the
machine for accepting a firmware switch number.
(6) Repeat steps (2) through (5) until the modification for the desired firmware switches is
completed.
(7) Press the Stop
key to return the machine to the initial stage of the maintenance mode.
NOTES: • To cancel this operation and return the machine to the initial stage of the maintenance
mode during the above procedure, press the Stop key.
• If there is a pause of more than one minute after a single-digit number is entered for
double-digit firmware switch numbers, the machine will automatically return to the
initial stage of the maintenance mode.
n
nn
n Details of Firmware Switches
The details of the firmware switches are described in Appendix 2 in which the user-accessible
selectors of the firmware switches are shaded.
To Next Page
Loading...
