IV - 20
3) Turn the gear 17/97 to move the CCD unit to the right to make the following job easier.
4) Remove screw "a" and take out the CCD rail clamp. (See the illustration given on the next
page.)
5) Remove two screws "b" from the CCD idle pulley holder, then remove the CCD drive belt from
the idle pulley.
6) Lift up the CCD rail together with the CCD unit and CCD drive belt, and then disconnect the
CCD flat cable.
NOTE: When handling the CCD unit, do not touch the CCD PCB or glasses but hold the
hatched sections as shown below.
7) Pull out the CCD rail from the CCD unit.
8) Remove the CCD lock.
"a": Taptite, cup B M3x8
"b": Taptite, pan B M3x10
To Next Page
Loading...
