Home > Set Up Your Label Printer > Install Batteries
Install Batteries
To ensure memory backup, we recommend using six new AA alkaline batteries (LR6) along with the AC Adapter.
NOTE
• To safeguard and back up the Label Printer’s memory, when the AC Adapter is unplugged, we
recommend having AA alkaline batteries installed in the Label Printer.
• When power is disconnected for more than two minutes, all text and format settings will be cleared. Any
text files saved in the memory will also be cleared.
• Remove the batteries if you do not intend to use the Label Printer for an extended period of time.
• Dispose of the batteries at an appropriate collection point, not in the general waste stream. In addition, be
sure to observe all applicable federal, state, and local regulations.
• When storing or discarding the batteries, wrap them (for example, with cellophane tape, as illustrated), to
prevent them from short-circuiting.
1. Cellophane tape
2. Alkaline battery
1. Open the Battery Compartment Cover.
2. Install six new AA alkaline batteries (LR6).
Make sure they are installed in the correct direction.
3. Close the Battery Compartment Cover.
To remove the batteries, reverse the installation procedure.
Related Information
• Set Up Your Label Printer
15
To Next Page
Loading...
Need help?
General
