Measuring Ampifier Type 2525
User Manual Vol.2
Brüel & Kjær
5–16
Chapter 5 – General Control Messages
Status and Configuration Check
5.3.4 Configuration Check
Configuration?
Configuration? returns information about the versions of the hardware (HW) (Mas-
ter Module and Measure Module) and software (SW) running in each module. In
addition, the presence of an additional filter module is indicated by a filter IDentifi-
er (string) field. This information can also be obtained by accessing the built-in self-
test program using the appropriate pushkey sequence on the amplifier – see Vol. 1,
Chapter 3.
In the case of the Type 2525 amplifier, the channel count is always 1.
Example (long):
:Configuration 0,1,0,1,1,32,1,0,1,"No internal filter connected Channel 1"
Fig.5.14 Syntax for Configuration? query and amplifier response
941151e
Te
CONFIGURATION?
To 2525
:
Header OFf
Te
From 2525
Configuration
SW ID
:
Configuration
Configuration
SP
—
CONFIGURATION
Measure Module
HW ID
NR1
Measure Module
SW ID
SW ID
Optional Filter ID
String(84)
,
,
Master Module
HW ID
NR1
Master Module
SW ID
SW ID
See below
Channel Count
NR1
,
,,
Version
NR1
Revision
NR1
History
NR1
,
,
See below
To Next Page
Loading...
