Measuring Ampifier Type 2525
User Manual Vol.2
6–3
BE1394– 11
Chapter 6 – Set-up and Display (Results) Messages
The Channel_1 Header
Example (long):
:Channel_1:Measurement_Mode Acceleration;Transducer_Sensitivity 1E-12;
Input_Type Charge_Single_Ended;Input_Gain -20;Fine_Gain 0;Output_Gain 0;
Upper_Frequency_Limit 10000;Lower_Frequency_Limit 1;
Additional_Filter None;Rms_Averaging_Time Exponential,1;
Peak_Hold_Time 5;Auto_Range OFf;Alarm_On_Off OFf;Alarm_Detector
Rms,1.26E+08;Alarm_Hold_Time 1;Alarm_Level_Exceed_Time 1;
Detector_Dc_Output Rms;Reference_Generator OFf;
Mounted_Impulse_Frequency 3E+04;Measurement_Status_Enable 0;
Operation_Complete_Enable 0
Example (short):
:C_1:M_M A;T_S 1E-12;I_T C_S_E;I_G -20;F_G 0;O_G 0;U_F_L 10000;
L_F_L 1;A_F N;R_A_T E,1;P_H_T 5;A_R OF;A_O_O OF;
A_D R,1.26E+08;A_H_T 1;A_L_E_T 1;D_D_O R;R_G OF;M_I_F 3E+04;
M_S_E 0;O_C_E 0
Example (off):
A;1E-12;C_S_E;-20;0;0;10000;1;N;E,1;5;OF;OF;R,1.26E+08;1;1;R;OF;3E+04;0;0
To Next Page
Loading...
