BTX ECM630 - Specialty Electrode Integration

19
Publicaon 5423-020-REV 1.0 • www.btxonline.com
Using Specialty Electrodes
Plug the specialty electrodes into the front ports of the
BTX ECM 630.
Scroll through available protocols.
Double tap desired selecon (Preset Protocol or User Protocol).
Scroll through available ssue/cell types.
Double tap desired ssue/cell.
Review parameters.
Posion electrodes on area being electroporated.
To run tap the Omega icon.
57
80
81
55
56
With load measurement OK, press the Green ‘Go’ icon to run
protocol.
While the pulse is being delivered, the Red ‘x’ icon can be used to
stop the protocol at any me.
79
Using an HT Plate Handler (connued)
Once protocol is complete, data regarding your pulse is displayed
and stored in the systems logs for future use.
You may connue pulsing, go back to the sengs screen or
protocol select screen, or to the home screen.
Using Specialty Protocols
NOTE: Generator will display readings aer rst and last pulse.