BTX ECM630 - Safety Precautions and High Voltage Risks; Preventing Hazard and Injury; High Voltage Hazard Warning; Laboratory Use and Flammability Caution

3
Publicaon 5423-020-REV 1.0 • www.btxonline.com
Please read the following safety precauons to ensure proper
use of your generator. If the equipment is used in a manner not
specied, the protecon provided by the equipment may be
impaired.
To Prevent Hazard or Injury
Use Proper Line Cord
Use only the specied line cord for this product and make sure
line cord is cered for country of use.The operang voltage range
for the ECM 630 system is 100–240 vac, 50/60 Hz.
Ground the Product
This product is grounded through the grounding conductor of the
power cord. To avoid electric shock, the grounding conductor must
be connected to earth ground. Before making any connecons
to the input or output terminals of the product, ensure that the
product is properly grounded.
Make Proper Connecons
Make sure all connecons are made properly and securely. Any
signal wire connecons to the unit must be no longer than
three meters.
Observe All Terminal Rangs
Review the operang manual to learn the rangs on all
connecons.
Use Proper Fuse
Use only specied fuses with product.
Avoid Exposed Circuitry
Do not touch any electronic circuitry inside of the product.
Do Not Operate with Suspected Failures
If damage is suspected on or to the product do not operate
the product. Contact qualied service personnel to perform
inspecon.
Orient the Equipment Properly
Do not orient the equipment so that it is dicult to operate the
disconnecon device.
Place Product in Proper Environment
Review the operang manual for guidelines for proper operang
environments.
Observe All Warning Labels on Product
Read all labels on product to ensure proper usage.
Caution Risk of
Electric Shock
Caution
Protective Ground
Terminal
High Voltage Risk
These instruments contain a high voltage power supply adjustable
to 3,000 V. High voltage power supplies present a serious risk of
personal injury if not used in accordance with design and/or use
specicaons, if used in applicaons on products for which they
are not intended or designed, or if they are used by untrained or
unqualied personnel.
• The user must read this manual carefully before the
instruments are placed into operaon.
• Removing the cover will void the warranty.
• Do not connect or disconnect the high voltage cable with
the high voltage enabled.
• To connect or disconnect the cable, turn line power o and
unplug line (mains) cord.
• Do not touch the electrode p while the waveforms are
being applied.
If there are any quesons about the operaon of this instrument,
call BTX Customer service at 1-800-272-2775, or 1-508-893-8999.
Cauon Noce
The ECM 630 Exponenal Decay Wave Electroporaon System is
intended for laboratory use only and can be used in research and
development applicaons. These systems have been designed
to meet the standards for electromagnec compability (EMC)
intended for laboratory equipment applicaons as well as the
applicable safety requirements for electrical equipment for
measurement, control, and laboratory use. The unit itself does
not generate waste, but may be used to treat samples that are
hazardous. Please use appropriate PPE and ensure disposal in
accordance with local regulaons and pracces.
This product should not be used in the presence of a ammable
atmosphere such as an anesthec mixture with air, oxygen, or
nitrous oxide.
Safety Information