BTX ECM630 - Device Updater Program for Firmware

32
Publicaon 5423-020-REV 1.0 • www.btxonline.com
1. Upload the latest soware versions to your desktop
(format is lename.srec). There are two .srec les that both
need to be updated: ‘BTX Gemini 7 vx.x.x’ and a
BTX Gemini 7 Pwr vx.x.x’.
2. Disconnect all I/O devices and then connect the ECM 630
generator to the PC using a USB cable.
3. On the setup screen of the ECM 630 generator, press
the Upgrade Soware icon twice to enter Boot Loader
Mode.
4. Download the soware from the BTX website
www.btxonline.com. Click on the Technical Resources
drop-down menu and select Downloads. Download and
install le named Firmware Updater.
5. Click Open Update File and browse to the BTX Gemini 7
vx.x.x.srec’. le that was previously saved to the desktop.
6. Click Start Update.
7. Aer the update is complete, press Reboot and then power
cycle the ECM 630 generator from the power switch in the
back of the unit.
8. Repeat steps 5 through 7 with the BTX Gemini 7 Pwr
vx.x.x.srec’.
Device Updater Program
Upgrading ECM 630 Series Software
NOTE: Prior to upgrading, users will need to install USB
drivers as well as the bootloader driver le. Reference ‘Virtual
Comport Driver Installaon’.
NOTE: To exit boot loader mode without upgrading the soware,
power cycle the generator.