Advanced programming options
9
Logamatic 2107 controls - We reserve the right to make any changes due to technical modifications. 49
Deleting a heating phase
A heating phase consists of two switching points, e.g. a start and a stop time. If
you wish to delete a heating phase, you will have to delete both switching points.
Example
Starting from the "NOON" standard program, you wish to delete the heating
phase on Monday from 11.30am – 1.00pm so that there is a heating pause from
8.00am – 5.00pm:
z Open flap.
AUTOMATIC
11.15am
71
Fig. 15 Deleting a heating phase
Day mode
Night mode
Day mode
Night mode
"NOON" standard program
New program "OWN PROG 1"
6.00am 8.00am 11.30am 1.00pm 5.00pm 11.00 pm
6.00am 8.00am 5.00pm 11.00pm
Before:
After:
+
Hold down the "Heating zone" key and turn the dial until "CIRCUIT 1" is
displayed.
Release the "Heating zone" key.
+
Hold down the "PROG" key and turn the dial until the desired standard program
(in this case "NOON") is displayed.
The "NOON" standard program has now been selected.
Release the "PROG" key.
The display shows the first switching point for the "NOON" standard program (in
this case "6.00am").
Turn the dial until the switching point of the heating phase that you wish to delete
is displayed, e.g.: 11.30am".
+
Hold down the "Time" key and turn the dial to the desired value (in this case
"1.00pm").
To Next Page
Loading...
Need help?
General
