1110 - 3
DIGITAL INDUSTRIAL CONTROLLER
english
1 GENERAL SAFETY INSTRUCTIONS
To ensure that the device functions correctly, and will have a long service life, please
comply with the information in these Operating Instructions, as well as in the
application conditions and the additional data given in the data sheet:
• When planning the application of the device, and during its operation, observe
the general technical rules!
• Installation and maintenance work should only be carried out by specialist staff
using the correct tools!
• Observe the relevant accident prevention and safety regulations for electrical
equipment during the operation and maintenance of the unit!
• If the controller is part of a complex automation system, a defined and controlled
re-start must be carried out following an interruption of operation.
• Always switch off the voltage before carrying out work on the device!
• Take suitable measures to prevent unintentional operation or impermissible
impairment.
• If these instructions are ignored, no liability will be accepted from our side, and
the guarantee on the device and on accessory parts will become invalid!
To Next Page
Loading...
Need help?
General
