HOW TO OPERATE THE 161 AS A DATA SERVER?
32
H D S
In server mode, the device functions as a pure data server. Access to the hard disk and
streaming of data, for example for multi-room playback, is available while all other
functions are de-activated. This operating mode uses much less power than normal
operation.
Server mode can be activated via the iPad® app in the Settings > Power menu or using
the web interface in the setup menu under System > Settings > General.
Please see the operating instructions “ Instructions for Operation via the iPad® App” and
“Instructions for Operation via a Web Browser” for further information.
H S N V
You can query the serial number and software and firmware version of your device by
using the remote control:
►
Press the OSD button the remote control, then press 2 – 2 – 2.
ª The serial number (SNR), software version (VERS), and firmware version (FW)
of your device appear in sequence on the display.
H S U
You can update the software on your 161 online or via a USB stick.
Updating online
The online update is started via the web interface or via the iPad®. Please see the
separate documents for more detailed information.
Note: For online updates the installation files are downloaded to your device from the
Burmester server. You need an Internet connection with sufficient bandwidth.
Updating via a USB stick
1. Save the current software on a USB stick. You can obtain the current software from
your specialist dealer.
2. Plug the stick into the USB slot on the front panel or into one of the slots on the rear
panel of the Phase 3.
3. On the remote control, press the OSD button, then the buttons 2 – 5 – 8.
ª The LEDs on the left side of the device panel light up red.
4. Press the OK button on the remote control.
ª The update starts.
ª The LEDs flash and the display shows “Firmware Update in progress”.
ª After the update has been completed the device reboots.
To Next Page
Loading...