What to do if my BUSCH R5 Water Pump does not reach the usual pressure on the suction connection?
If your BUSCH Water Pump isn't reaching the usual suction pressure, it could be due to several reasons. Check the oil level and top it up if it's low. The inlet filter cartridge might be partially clogged and require replacement. If these steps don't resolve the issue, internal parts may be worn or damaged.
Why can't I control my BUSCH R5 via the User Interface?
If your BUSCH Water Pump cannot be controlled via the User Interface, the machine might be in Automatic or Remote control mode. Switch the control to Local / Manual mode.
What to do if the oil in my BUSCH R5 Water Pump is emulsified?
If the oil in your BUSCH Water Pump is emulsified, it might be because the machine sucked in liquids or significant amounts of vapour, in this case, contact Busch to flush the machine. You should also clean the filter of the gas ballast valve. Consider modifying the operational mode.
What to do if the drive motor is running, but the BUSCH R5 stands still?
If the drive motor of your BUSCH Water Pump is running, but the pump itself is not, the coupling between them might be defective. In this case, replace the coupling element.
What to do if my BUSCH Water Pump runs at atmospheric pressure for a long period?
If your BUSCH Water Pump runs at atmospheric pressure for a long period, make sure that the machine operates under vacuum.
Why does my BUSCH R5 run too hot?
If your BUSCH Water Pump is running too hot, several factors could be responsible. Insufficient cooling may be the issue, so remove any dust and dirt from the machine. Also, ensure that the ambient temperature is within the permitted range. Check the oil level and top up if it is too low. Finally, the exhaust filters may be partially clogged; in this case, replace them.
Why does my BUSCH R5 Water Pump machine fume or expel oil droplets through the gas discharge?
If your BUSCH Water Pump is fuming or expelling oil droplets, the exhaust filters might be partially clogged, so replace them. Also, check the position of the exhaust filters and the o-rings to ensure they are fitted correctly. Finally, the float valve may not be working properly, so check the float valve and the oil return line, repairing if necessary.
Why is my BUSCH R5 Water Pump expelling operating fluid?
If your BUSCH Water Pump is fuming or expelling operating fluid, check the exhaust filter to ensure it's properly seated. If not, reposition it correctly. Also, inspect the o-ring and add or replace it if it's missing or damaged. If the exhaust filter shows cracks, replace it.
What to do if BUSCH R5 does not reach the usual pressure?
If your BUSCH Water Pump isn't reaching its usual suction pressure, it could be due to several reasons. First, check the oil level and top it up if it's low. A partially clogged inlet screen could also be the culprit, so clean it. If your pump has an optional inlet filter cartridge, try replacing it. If these steps don't resolve the issue, internal parts may be worn or damaged, in which case you should contact Busch for repair.
How to deal with exhaust filter clogged with foreign matter in BUSCH R5?
The saturation of the exhaust filter with operating fluid is normal and doesn't impair its function. If the exhaust filter is clogged with foreign matter, replace the exhaust filter.
Specifies environmental and spatial requirements for proper installation.
Details on safe and correct electrical hook-up for the machine.
How to select and manage operating modes like Local, Remote, Manual, Auto.
Details on Speed Control and Pressure Control operating modes.
Information on warning and alarm signals and their causes.
Recommended maintenance tasks and intervals for normal/harsh use.
Provides solutions for common problems and error messages.
General| Brand | BUSCH |
|---|---|
| Model | R5 |
| Category | Water Pump |
| Language | English |
To Next Page
