BYD S1 EV - Page 234

234
7-1 In case of a fault
■ Turn the wheel nuts
counterclockwise to loosen them.
Tip
● Hold the end of the wrench handle down and do not allow the wrench to slide out
from the nut.
● Do not remove the nuts, but just loosen them 1~2 turns.
Warning
● Do not apply oil or lubricant on the bolts or nuts. Otherwise, the nuts will be loosened,
resulting in its falling off and even a serious accident.
Position the jack
4. Place the jack at the correct jacking
point as shown.
■ Confirm that the jack is placed on a
flat and stable surface.
Note
● Confirm that the car is jacked properly, otherwise the car may be damaged.