BYD SEAL EV - Page 147

1 A/C setting
2 Air puri󽗉cation system
3 Seats Ventilation/Heater button
4 A/C operation interface button
5 A/C Switches
6 Auto mode
7 A/C button
8 Max. cooling button
9 Ventilation
10 Front windshield defrost
11 Rear defroster button
12 Internal/External circulation
13 Anion button
14
Front passenger A/C temperature
adjustment
15 Air amount regulation
16 Blowing mode
17
Driver A/C temperature
adjustment
18 Independent control
REMINDER
• A/C odor:
•It is normal that there may be
a damp and moldy smell just
after the A/C is turned on. During
the operation of the automobile
A/C, A/C condensation often
remain in the evaporator, and
the wet evaporator can easily
absorb un󽗉ltered body sweat,
smokes, etc., inside the vehicle.
Condensation not blown dry
makes the dark and damp
evaporator surface prone to
mold, which is very likely to
produce unpleasant odors by
long-term fermentation.
•
How to prevent A/C odors:
•Turn o󽗈 the A/C and ventilate
with natural air before parking
to keep the air inside the vehicle
relatively dry.
•
Inspect, clean, or replace the
󽗉lter regularly.
•Try to keep the cabin clean and
fresh.
• If the odor persists after odor
prevention methods are used, it
is recommended to contact a
REMINDER
BYD authorized dealer or service
provider for repair.
Functional De󽗉nition
Auto mode
• Tap the auto button, its indicator lights
up on the front A/C panel, the auto
mode is activated.
•
If any manual control button is
pressed in automatic operation mode,
the corresponding status of the
button pressed will be set and other
statuses will continue to be adjusted
automatically.
A/C power button
•
Press this button or tap “ON” on
the A/C operating interface to turn o󽗈
the A/C. The air outlet mode keeps
unchanged, while the air input mode
turns to recirculation mode. Press this
button or tap “ON” again to turn on
the A/C.
• With the A/C turned o󽗈, press this
button or tap “ON” to turn on the
A/C in the memorized modes, with the
set temperature, blower speed and air
146