BYD TANG 2024 - Driving Range Display

CAUTION
unlocked. Otherwise, the electric
lock will lock again.
●
After the vehicle is fully charged,
the charging connector will be
automatically unlocked when the
anti-theft mode of the charge port
is disabled. When this mode is
enabled, the charging connector
must be manually unlocked
following the above steps.
Emergency Unlocking of the Charge
Port
When the electric lock fails and the
charging connector cannot be unplugged,
try to unplug the charging connector by
manually unlocking the charge port.
1. Open the trunk lid.
2.
Pull out the armrest frame on the right
side of the trunk and 󽗉nd the red plug
cap.
3. Slightly pull the emergency rope to
unlock the charging connector.
4. Reset the emergency cable latch after
the unlocking is complete.
REMINDER
●
If the above functions are
abnormal or fail, contact a
BYD authorized dealer or service
provider.
Driving Range Display
The range display mode can be set to
improve driving experience. The default
setting is standard mode. You can change
it by going to infotainment touchscreen
→ Energy.
●
Standard mode: displays the driving
range based on the result of
comprehensive working condition test.
●
Dynamic mode: displays the estimated
driving range based on the available
battery power and current average
energy consumption.
●
The set driving range display mode is
memorized by the system. When the
vehicle is powered o󽗈 and then on,
the display mode set last time will be
maintained.
REMINDER
●
When the Dynamic range display
mode is set:
●
The driving range that is
displayed after a full charge may
103
04
USING AND DRIVING